1. Overview: Location and Function of Parts
10
AXS memory card slot block (page 26)
The AXS memory card slots are located behind
the cover.
1
1.
AXS memory card slots A/B
Assistant Side
1 2 3
4
6
5
7
8
9
10
11
12
13
14
15
16
17
18
19
1
2
3
4
5
6
Air vent
1.
ASSIGN (assignable) button 4 (page 48)
Assign functions using the EDIT page of the
user functions screen (page 48).
The assigned function toggles between on/off
(enabled/disabled) or is activated with each
press.
2.
ASSIGN (assignable) lamp 4 (page 48)
The lamp is lit orange when the assigned
function is on (enabled) or activated, and not
lit when the function is off (disabled).
3.
Sub display
Allows you to check the operation status
of the unit and make various settings
(page 36).
With the Home screen displayed, press and
hold the BACK button (page 11) and turn
the MENU dial to adjust the brightness of the
sub display and mini display.
The brightness can also be adjusted using
Technical > Panel Control > Brightness level
(page 89) in the full menu.
4.
Sub display ITEM keys 1 to 6
Controls the operation of functions on the sub
display (page 54).
5.
Tape measure hook
The tape measure hook is on the same plane
as the image sensor. To measure the precise
distance between the unit and the subject,
use the tape measure hook as a reference.
You can attach the end of a tape measure to
the hook, and measure the distance from the
subject.
6.
HOME button
Press to clear the display and return to the
Home screen on the sub display (page 38).
If pressed when the unit is in playback state,
the unit transitions to shooting mode.
7.
MENU (menu display on/off) button
(pages 54, 64)
Press the MENU button to display the menu
screen on the sub display. Press and hold
the MENU button for 2 seconds or longer
to display the full menu screen on the sub
display.
You can also press the MENU button together
with the MENU dial to quickly display the full
menu screen.
Press the button during menu screen or full
menu screen display to return to the previous
screen display.
8.
SEL/SET (select/set) dial (MENU dial)
Changes the item selection or a setting within
the menu (pages 38, 54, 64).
9.
+48V power lamp
Lights in green if the AUDIO IN switch is set to
MIC and +48 V phantom power is supplied on
the AUDIO IN connector. It is not lit if phantom
power is not supplied.
You can turn +48 V phantom power on/
off using Audio category > Audio Details >
Audio Configuration > Phantom Power +48V
(page 84) in the menu.
10.
AUDIO IN (audio selector) switch
Select the input signal type corresponding to
the audio source connected to the AUDIO IN
connector.
LINE: When connecting an external analog
audio signal source
AES/EBU: When connecting an external digital
audio signal source
MIC: When connecting a microphone
