Sony MDR NC60 - Headphones - Binaural, Руководство по обслуживанию, Страница: 3 / 26

3
MDR-NC60
SECTION 1
GENERAL
This section is extracted from
instruction manual.
Features
• Noise canceling headphones reduce unwanted
ambient noise, providing a quieter environment
to enhance your listening experience. A
microphone inside each earpiece works with
electronic circuitry to create an opposite sound
wave to cancel out the noise. Up to 85 %
ambient noise cancellation (Over 16.5 dB is
reduced at 200 Hz)
• Slim, folding design for easy portability
• Neodymium magnets for powerful sound
• Dual-use capability allows option to listen to
music with or without noise cancellation
• Built-in monitor function lets you silence the
audio to listen outside
• Supplied plug adaptor for easy connectivity to
stereo or dual jack for in-flight music services
Installing a battery
1
Push the “BATT
Z
” button located at the
bottom of the right housing.
The lid of the battery box opens slightly.
2
Open the lid of the battery box of the
headphone to insert one size AAA
battery.
1
2
Note
The lid of the battery box opens only so far,
as shown in the illustration. Do not further
force open the lid as it may damage it.
3
Close the lid.
Right housing
Match the
e
on the
battery to the e in the
battery case.
To remove the battery
Open the lid of the battery box, then push the
position marked with “PUSH
G ”. The e side of
the battery comes up. Remove the battery by
pulling it.
1
2
If the lid of the battery box is
detached
Follow the procedure below to reattach the lid.
1
Attach the lower side of the lid.
2
Push the upper side of the lid straight
forward until it clicks into position.
Listening to music
1
Connect the headphones to the AV
equipment.
* “WALKMAN” and “WALKMAN” logo are
registered trademarks of Sony Corporation.
Notes
• When connecting the cord, insert the plug into
the jack until the green portion of the plug
disappears.
OK
• To disconnect the cord, pull it out by the plug,
not the cord, as the inner conductors may break.
2
Turn on the power on the right side of the
headphones.
The POWER indicator lights in red. When the
power is turned on, ambient noise is reduced,
and you can listen to music more clearly at a
lower volume.
3
Put on the headphones so that the ear
pads cover your ears.
R L
L R
When connecting to the stereo mini jack
of the remote control’s jack supplied with
a WALKMAN

, etc.
Remote control
When connecting to the
stereo mini jack of a
WALKMAN

* , etc.
Connecting cord 1.5 m
(supplied)
Headphones
Connecting cord 0.5 m
(supplied)
OFF
ON
PO
WER
L R
Noise canceling microphone
4
Turn on the power of the AV equipment.
Hearing environmental sound for
safety
If the MONITOR switch is pressed and held
while the POWER switch is set to ON, playback
silences so you can hear the surrounding
environment.
Note
The environmental sound might not be heard if
the microphone is covered with your fingers.
Notes on using on the
airplane
• The supplied plug adaptor can be connected to
dual and stereo mini jacks.
• Do not use the headphones when use of
electronic equipment is prohibited or when use
of personal headphones for in-flight music
services is prohibited.
If you have any questions or problems concerning
the system that are not covered in this manual,
please consult the nearest Sony dealer.
After listening to music
Turn off the power of the headphones.
Folding the
headphones
Folding
The housings rotate to make them flat for easy
storage in the carrying case (supplied), or in a seat
pocket.
Restore to their usual position before using.
for dual jacks for stereo mini jacks
L R
Monitor microphone
MONITOR
switch