60
Tape Deck
The tape does not record.
•No tape is in the cassette holder.
•The tab has been removed from the
cassette (see page 57).
•The tape has reeled to the end.
The tape does not record nor play, or there
is a decrease in sound level.
•The heads are dirty. Clean them (see page
57).
•The record/playback heads are
magnetized. Demagnetize them (see page
57).
The tape does not erase completely.
•The record/playback heads are
magnetized. Demagnetize them (see page
57).
There is excessive wow or flutter, or the
sound drops out.
•The capstans or pinch rollers are dirty.
Clean them (see page 57).
Noise increases or the high frequencies are
missing.
•The record/playback heads are
magnetized. Demagnetize them (see page
57).
Tuner
Severe hum or noise (“TUNED” or
“STEREO” flashes in the display.
•Adjust the antenna.
•The signal strength is too weak. Connect
an external antenna.
A stereo FM program cannot be received in
stereo.
•Press STEREO/MONO so “STEREO”
appears in the display.
If other problems not described
above occur, reset the system as
follows:
1
Unplug the power cord.
2
Plug the power cord back in.
3
Press SPECTRUM ANALYZER, ENTER,
and DISC 1 at the same time.
Specifications
Amplifier section
The following measured at AC 120/240 V, 50 Hz
DIN power output (Rated)
FRONT SPEAKER:
105 + 105 watts
(6 ohms at 1 kHz, DIN)
CENTER SPEAKER:
20 watts
(8 ohms at 1 kHz, DIN)
REAR SPEAKER:
10 + 10 watts
(16 ohms at 1 kHz, DIN)
Continuous RMS power output (Reference)
FRONT SPEAKER:
130 + 130 watts
(6 ohms at 1 kHz, 10 %
THD)
CENTER SPEAKER:
25 watts
(8 ohms at 1 kHz, 10 %
THD)
REAR SPEAKER:
12.5 + 12.5 watts
(16 ohms at 1 kHz, 10 %
THD)
The following measured at AC 220 V, 50 Hz
DIN power output (Rated)
FRONT SPEAKER:
100 + 100 watts
(6 ohms at 1 kHz, DIN)
CENTER SPEAKER:
18 watts
(8 ohms at 1 kHz, DIN)
REAR SPEAKER:
9 + 9 watts
(16 ohms at 1 kHz, DIN)
Continuous RMS power output (Reference)
FRONT SPEAKER:
120 + 120 watts
(6 ohms at 1 kHz, 10 %
THD)
CENTER SPEAKER:
23 watts
(8 ohms at 1 kHz, 10 %
THD)
REAR SPEAKER:
11.5 + 11.5 watts
(16 ohms at 1 kHz, 10 %
THD)
Peak music power output (Reference)
2,000 watts
Inputs
PHONO IN (phono jacks):sensitivity 3 mV,
impedance 47 kilohms
VIDEO (AUDIO) IN (phono jacks):
sensitivity 250 mV,
impedance 47 kilohms
MIX MIC (phone jack):
sensitivity 1 mV,
impedance 10 kilohms
Troubleshooting (continued)