27
9. Plasma Panel Replacement - KZ-42TS1U
•
Attach the conductive mesh tape between the bezel and plasma panel (refer to Figure 9-6).
•
If you want to test the TV before installing the shield, attach the rear circuit board assembly, plug it in and turn
on the TV set. Without the rear shield in place, you will get horizontal lines of interference on the TV channels
from the power supply. After testing, remove the rear circuit board assembly to install the shield.
•
Install the rear shield with the decorative top control panel. Put the top ferrite assembly inside the shield or
you will not be able to fasten the rear cover later on. Make sure the shield mates with the metal on all four
sides to complete the shield.
•
Attach the rear circuit board assembly.
•
Replace the two conductive mesh tapes over the upper and lower holes in the rear shield (refer to Figure 9-
2).
•
Put the back cover in place
