124
Ot
her
I
n
fo
Other Inf
o
General
Problem
Possible Remedies
How to restore Video settings
to factory settings
s
Press
RESET
on the remote control while in the Video menu (see page 100).
How to restore Audio settings
to factory settings
s
Press
RESET
on the remote control while in the Audio menu (see page 103).
Cannot cycle through the other
video equipment connected to
the TV
s
Be sure the
Video Label
option is not set to
Skip
(see page 113).
Cannot operate menu
s
If a menu option appears in gray, this indicates that the menu option is not
available.
Lost password
s
In the password screen (see page 109), enter the following master password:
4357
. The master password clears your previous password; it cannot be used to
temporarily unblock channels.
s
The i.LINK STANDBY LED blinks when the signal from an i.LINK device is
being shown.
LED on the display unit is lit
s
The POWER ON/STANDBY LED (see page 18) lights up when the TV is turned
on. If the LED blinks continuously, this may indicate the TV needs a service.
s
The TIMER LED (see page 18) indicates that the timer is set. When the timer is
set, this LED will remain lit even when the TV is turned off.
s
If the STANDBY LED blinks, disconnect the AC power cord and leave the TV for
three minutes to check that it stops blinking. If the LED does not stop blinking,
contact qualified Sony personnel.
The signal from a selected
i.LINK device is not being
displayed
s
If you have several i.LINK devices connected and operating at once, the TV may
not be able to display the signal from the selected device. Turn the other i.LINK
devices off, and reselect the desired i.LINK device.