29
5-6-4. Auto Check
(See page 32)
Start
YES
NO
NO
NO
NO
NO
NO
NO
NO
YES
YES
YES
YES
YES
YES
YES
Replace IC195
Replace OP or IC195
Replace IC101, IC195, or D101
5-11. Iop NV SAVE (See page 35)
Replace OP, IC190, or IC195
Replace OP, IC102, IC190,
or IC195
Replace OP, IC101, IC151,
or IC195
Replace OP
Replace the spindle motor
End adjustments
After turning off and then on the power,
initialize the EEPROM
For details, refer to 4-11. WHEN MEMORY NG IS
DISPLAYED (See page 26)
• Abbreviation
OP: Optical pick-up
5-7. INITIAL SETTING OF ADJUSTMENT VALUE
(See page 34)
5-9. TEMPERATURE COMPENSATION OFFSET
ADJUSTMENT (See page 34)
5-10. LASER POWER ADJUSTMENT (See page 34)
5-12. TRAVERSE ADJUSTMENT (See page 35)
5-13. FOCUS BIAS ADJUSTMENT (See page 36)
5-16. AUTO GAIN CONTROL OUTPUT LEVEL
ADJUSTMENT (See page 37)
OP change in Err Display mode
Iop write
Spdl change in Err Display mode
Adjustment flow
Содержание HMC-NX5MD
