Sony HKSR-101, Руководство по эксплуатации

Страница: 39 / 128

Chapt
er
3
P
rep
ar
at
ions
39
3-7 Handling Cassettes
To insert cassettes
1
Set the SRW-1 and SRPC-1 POWER ON/OFF
switches to ON.
2
Press the EJECT button.
The cover of the cassette insertion slot opens.
3
Check the following, and then insert the cassette.
• There is no slack in the tape. (If there is slack in the
tape, see “Removing slack in the tape”.)
• There is no error message in the display (see page
104) .
4
Press the cover of the cassette insertion slot to close it.
The tape is wound on the drum.
If “VTR 007F: HUMID ERROR” appears in the
display
Condensation was detected.
See “Condensation” (page 100) for the steps to take.
Removing slack in the tape
Carefully rotate one of the reels in the direction of the
arrow until it stops.
To eject cassettes
With the system powered on, press the EJECT button on
the control panel.
The tape is unthreaded and the cassette is automatically
ejected. This operation takes a few seconds.
To cancel the ejection before it is finished, press any of the
other operation buttons before the cassette is completely
ejected. The cassette ejection operation is canceled and the
operation corresponding to the button you pressed starts.
To remove a cassette with the system powered
off
Proceed as follows if you need to remove a cassette with
the SRW-1 powered off, because the battery pack is
exhausted or for some other reason.
There is no need to return the screw to its original position
after you remove the cassette. Normal operation resumes
again the next time you power the system on.
For the method of ejecting the cassette after a slack error
(forcible eject), refer to the Maintenance Manual.
1
4
3
2
Cassette insertion slot
1 Power off the SRW-1 and
SRPC-1.
2 Open the rubber cover by
pressing the depression on the
left side of the cover with your
finger, pushing it toward the
right, and lifting up the left edge
of the cover.
3 Use a screwdriver to press in the
screw inside, and rotate the
screw in the clockwise direction
until the cassette insertion slot
cover opens.