Sony HDCU-F950, Руководство по установке и обслуживанию

Страница: 59 / 62

3-9 (E)
HDCU-F950 IMM
* DTX Diag *
Return Setting:Remote
Return Delay :1Field
RET4(VBS) :ON
Return FC mode:Auto
PLD V1.00 Config Done
DTX Mode Normal
1
2
3
4
5
6
* DRX Diag *
CB Select
Bar-16:9(100%)
PLD V1.00 Config Done
DRX Mode Normal
1
2
3
Page 10
DTX Diag Dispaly
Displays the details of self-diagnosis of the DTX-1A board
of the unit.
No. Contents
1
Setting state of S605 on the DTX-1A board (HD/SD/
Remote)
* 5
2
Setting state of the phase (setting of S607-1 on the DTX-
1A board) with the SD return signal during up-conversion
(SYS/MIN)
* 5 (not used)
3
Setting state whether the PROMPTER connector on the
rear panel is used or not with REM4 (setting of S607-2 on
the DTX-1A board) (ON/OFF)
* 5 (not used)
4
State of the frame frequency conversion mode (setting of
S606 on the DTX-1A board) of the return signal (Through/
A/B/Auto)
*
5
5
Displays the state of the PLD (IC401 on the DTX-1A
board) version and PLD. (Config Done/Config NG)
Config Done : PLD (IC401 on the DTX-1A board) started
correctly.
Config NG : PLD (IC401 on the DTX-1A board) did not
start correctly.
6
State of the operation mode on the DTX-1A board
(Normal/Test)
* 5 : For details, refer to Section 1-6-5. “Setting of Switches on Boards _
DTX-1A Board”.
Page 11
DRX Diag Dispaly
Displays the details of self-diagnosis of the DRX-1A board
of the unit.
No. Contents
1
Setting state of the HD output color bar (setting of S205
on the DRX-1A board)
* 6
2
Displays the state of the PLD (IC401 on the DRX-1
board) version and PLD (Config Done/Config NG)
Config Done : PLD (IC401 on the DRX-1A board) started
correctly.
Config NG: PLD (IC401 on the DRX-1A board) did not
start correctly.
3
State of the operation mode on the DRX-1A board
(Normal/Test)
*
6 : For details, refer to Section 1-6-4. “Setting of Switches on Boards
_
DRX-1A Board”.