Sony HDCU-F950, Руководство по установке и обслуживанию

Страница: 42 / 62

2-8 (E)
HDCU-F950 IMM
Setting the Microphone Output Level
AVP-4A board (A side)
Select the microphone output signal level (0 dB,
_
20 dBu)
from the MIC 1, 2 connector on the rear using the switches
on the AVP-4A board.
Setting the output level of MIC 1 :
Switch S503 (MIC 1 OUT LEVEL)
Setting the output level of MIC 2 :
Switch S603 (MIC 2 OUT LEVEL)
Factory setting : 0 dBu (both S502 and S503)
The microphone output signal level from the MIC 1, 2
connector on the rear can be adjusted using the volume on
the AVP-4A board.
Setting the output level of MIC 1 :
1 RV500 (MIC 1 OUT LEVEL)
Setting the output level of MIC 2 :
1
RV501 (MIC 2 OUT LEVEL)
2-4. Systems
2-4-1. Setting the Tally System
This unit supports the red tally and the green tally. It also
supports the MAKING CONTACT and supplying power
(24 V/TTL). Set the switches on the AVP-4A board
according to the system used as follows :
AVP-4A board (A side)
Set the tally system as shown in the following table.
Setting the tally system
Red tally Green tally
Switch S100 S102 S101 S103
MAKING CONTACT
_
CONTACT
_
CONTACT
Supplying POWER POWER POWER POWER
24 V power
Supplying POWER TTL POWER TTL
5 V power
Switches S100 and S101 are set to CONTACT when the unit is shipped from
the factory.
GH
J
K
S502 S503
1
RV501
1
RV500
GH
J
K
S101 S100
S102 S103
GH
J
K