Sony GDM-1962B, Руководство по установке

Страница: 6 / 8

POSITION ADJUSTMENT CONTROLS:
This monitor has 2 adjustments (H, L) for each of the controls below. The H (high
settings) is normally the default value and corresponds to 70 to 80 Khz opertaion.
The L (low settings) corresponds to 60 to 65 Khz operation.
V.SIZE or Vertical size adjustment control:
This is your vertical height adjustment. You need to center
the screen vertically first to get this correct.
V.CENT or Vertical center adjustment control:
This control will move the screen up or down (vertical
center). In some cases the companion video card will show
a bigger size for 640x480 and 1280x1024 resolutions than
the 1024x768. In this case if you want to be able to see most resolutions
completely, adjust the monitor for 1280x1024, so that 640x480 will fill up the
screen too.
H.FREQ or Horizontal frequency (kHz) adjustment control:
This needs to be adjusted if you get a scramble picture.
Scramble picture indicates a wrong Horizontal frequency is
getting to the monitor. Turn this control very slowly until
you get a stable picture. This process will effect all resolutions and also
Horizontal Positioning.
H.SIZE or Horizontal Size adjustment control:
This is the monitor’s width size adjustment, you need to
center the screen horizontally first before making this
adjustment. Sometimes increasing the Horizontal size to
the limits may cause the monitor to behave abnormal or the screen may become
shaky. Normally leave about 1/8 of inch of blank border on each side of the
screen, for the best result. This is needed for the proper monitor timing
adjustment.
PIN BAL or Screen geometry balance control:
Do not touch this control, unless the screen is not straight
from the sides.
V.LIN or Vertical Linearity control:
Do not touch this at all. This makes the vertical picture to
be closer in certain areas (to be less linear).
V. LIN BAL or Vertical linearity balance control:
Do not try to adjust this control.