Sony FDR-AXP33, Руководство по обслуживанию

Страница: 19 / 130

Self-diagnosis Code
Symptom/State Correction
Repaired by:
Block
Function
Detailed
Code
E 6 2 1 0 Shift lens initializing failure
Replacement of lens block.
*1
If an error occurs again, steadyshot circuit may be faulty.
Replace the board that contains this peripheral circuit.
E 6 2 1 1 Shift lens overheating (PITCH) Check signal line connections from CPU through steady-
shot IC to PITCH/YAW drive.
When there is no problem with the connections, check
whether this error is due to the lens or the board. Replace
the faulty lens or board.
E 6 2 1 2 Shift lens overheating (YAW) Check signal line connections from CPU through steady-
shot IC to PITCH/YAW drive.
When there is no problem with the connections, check
whether this error is due to the lens or the board. Replace
the faulty lens or board.
E 6 2 2 0 Abnormality of thermistor Check signal line connections from CPU through steady-
shot IC to PITCH/YAW drive.
When there is no problem with the connections, check
whether this error is due to the lens or the board. Replace
the faulty lens or board.
E 6 2 3 0 Abnormal CPU Turn power off and turn power on again. When this error is
not cleared, replace the board that mounts the CPU.
E 9 1
0 1 *2
Abnormality when flash is being
charged Check or replace the LED flash/video light or charging ca-
pacitor.
E 9 1
0 2 *2
Abnormality of LED video light Check or replace the LED flash/video light or charging ca-
pacitor.
E 9 1
0 3
*2 Abnormality of LED video light
Temperature detection Check or replace the LED flash/video light or charging ca-
pacitor.
E 9 2 0 1 Battery current value goes over the
max discharge current Confirm whether or not the symptom is occurred after re-
placing the battery. If the symptom is still occurred, replace
board.
E 9 4 0 0 Fault of writing or erasing the flash
memory The flash memory (Internal Memory) may be faulty.
Replace the board that contains this peripheral circuit.
E 9 4 0 1 Abnormality of Internal flash mem-
ory The flash memory (Internal Memory) may be faulty.
Replace the board that contains this peripheral circuit.
E 9 4 0 2 BGM data error The CPU may be faulty.
Replace the board that contains this peripheral circuit.
E 9 6
0 0
*2 Map area mount error The flash memory (Internal Memory) may be faulty.
Replace the board that contains this peripheral circuit.
E 9 6
0 0 *2
Map area mount error The flash memory (Internal Memory) may be faulty.
Replace the board that contains this peripheral circuit.
E 9 7 0 0 Projector hardware error Turn power off and turn power on again. When this error is
not cleared, the peripheral circuit of the projector may be
faulty.
Replace the board that contains this peripheral circuit.
*1: When the lens block was replaced, start the Adjust Manual in the Adjust Station and execute the necessary adjustment items. After
the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the handheld operation.
*2: Function of this code is not provided in this unit.
FDR-AX30/FDR-AX33/FDR-AXP33/FDR-AXP35
1-3