Sony FD Trinitron WEGA KV-36HS500, Руководство по обслуживанию

Страница: 20 / 420

— 20 —
KV-32HS500/32HV600/34DRC500/34XBR800/36HS500/
36XBR800/38DRC500/40XBR800/42DRC800
Raster Edge Equal:
RASTER
EDGES
RASTER
2-9. PICTURE DISTORTION ADJUSTMENTS
2-9.1. NTSC (DRC) FULL MODE
ADJUSTMENT
1. Face the picture tube in an east-west direction. (For best condition.)
2. Complete V-PIN and V-CEN adjustments fi rst (A2170-D1 06 V-PIN,
A2170-D1 05 V-CEN).
3. Input a monoscope and crosshatch signal. Adjust the picture
distortion with the following service parameters to balance the best
condition for these two signals.
NOTE
: Make sure that the picture size is within specs. Vertical size is
11.8 ± 0.1 sq. and horizontal size is 15.8 ± 0.1 sq.
4. Write data into memory before changing modes.
CXA2170D-1
Item 0. VPOS (V-POSITION)
Item 1. VSIZ (V-SIZE)
Item 3. VLIN (V-LINE)
Item 4. VSCO (VS-COR)
Item 9. HTPZ (H-TRAPEZOID)
CXA2170D-2
Item 1. HPOS (H-POSITION)
Item 2. HSIZ (H-SIZE)
Item 5. PIN (PIN AMP)
Item 7. UCP (UP COR PIN COR)
Item 8. LCP (LOW CO PIN COR)
Item 14. PPHA (PIN PHASE)
Item 15. VANG (AFC-ANGLE)
Item 16. LANG (L-ANGLE)
Item 17. VBOW (AFC-BOW)
Item 18. LBOW (L-BOW)
2-
9.
2
. 1
080
i
HD
MO
D
E A
D
JU
S
TMENT
1. Input a 1080i cross-hatch signal and an HD monoscope signal that
contains overscan markers.
2. Adjust the raster position per Section 2-8., only if this procedure was
not performed for full mode.
3. Adjust the geometry similar to Full DRC mode. Vertical size is 11.7
± 0.1 sq. and horizontal size is 15.6 ± 0.1 sq., if monoscope signal is
available. Otherwise, set the Vertical size to 91.0 ± 0.6% scan and
Horizontal size as 91.0 ± 0.6% scan.
4. Use the following register to adjust the horizontal parameter:
A2150-D2 01 HPOS
NOTE
: If necessary, touch up the geometry using the data register
listed above for Full mode. Check NTSC full mode for side
effect and balance.
5. Write the data into memory before changing modes.