Sony DXC-D35, Руководство по обслуживанию

Страница: 67 / 122

2-5
DXC-D35/D35WS(UC)
DXC-D35P/D35WSP(CE) V1
Front unit assembly
Screws
with washer
(B3
x 10)
Screws
with washer
(B3
x 10)
5. Remove the four screws to remove the front unit
assembly.
6. Remove the setscrew shown in the figure and take off
the filter knob.
7. Remove the four screws and four washers of the front
panel to remove the CCD unit.
n
Use great care to avoid any pressure on the PA board
when handling the CCD unit.
2-3. Replacement of CCD Unit
Description on CCD Block Number
Every CCD unit has its own ID number called CCD block
number. It shown the CCD block type and serial number
for the CCD block.
The CCD block number label is put in the CCD unit.
GUA xxxxx : DXC-D35 (NTSC)
GVA xxxxx : DXC-D35P (PAL)
HDA xxxxx : DXC-D35WS (NTSC)
HEA xxxxx : DXC-D35WSP (PAL)
Serial number for the CCD unit
CCD block type
1. Remove the lens and viewfinder. (Refer to the instruc-
tion manual.)
n
To protect the prism block, be sure to cover the lens
mount portion with the mount cap.
2. Remove the left side plate. (Refer to Section 2-2-1.)
3. Remove the AT board. (Refer to Section 2-2-2.)
4. Disconnect the harness connectors from the four
connectors (CN2, CN105, CN106 and CN107) and the
flexible card wire from the connector (CN103) on the
MB board.
n
When disconnecting the flexible card wire, refer to
Section 2-11.
CN105
CN106
CN107
CN123
CN103
CN2
MB board
Washer (SW3)
Washers (SW3)
Screws (B3 x 8)
Screw (B3 x 8)
Setscrew (3 x 4)
Front panel
Filter knob
CCD unit
2-3. Replacement of CCD Unit