7
Using the Cross Remote
This transmitter is equipped with a wireless remote control
function that can be used to set the parameters (low-cut
filter, attenuation operation, power save mode, etc.) of the
transmitter through the receiver or other devices. This
function makes it easier to operate and manage the
microphone system while in the field.
This wireless control is 2.4 GHz IEEE802.15.4 compliant
and has no effect on the RF band of digital wireless audio.
This function is activated when pairing is established
between the transmitter and the receiver using the RF
REMOTE function.
Pairing must be done first before the wireless remote
control function can be used.
If “RESTRICTED BY GP/CH SETTING” appears on the
RF REMOTE screen, the wireless remote control function
cannot be used. To use the wireless remote control
function, select a different transmission channel.
For details on how to change the transmission channel, see
“Setting the Transmission Channel” on page 6.
Pairing with a receiver
Pairing links the transmitter with the receiver which the
wireless remote control function is to be used.
When the transmitter has been paired with a receiver
through the receiver operation, turning on the transmitter
while holding down the – button establishes the pairing
immediately.
To carry out pairing through menu operations on the
transmitter, do the following.
1
Set the receiver to be used for controlling the
transmitter to pairing mode.
For details, refer to the operating instructions
supplied with the receiver.
2
Press the + or – button repeatedly until the RF
REMOTE indication is displayed.
3
Hold down the SET button until the item to be set
flashes.
4
Press the + or – button repeatedly to select PAIRING.
5
Press the SET button to enter.
The transmitter sends a pairing request to the receiver
which is on pairing mode.
Before established pairing, if you press any operation
key on the transmitter, pairing mode will be cancelled.
When pairing has been established, the wireless
remote control condition level (indicated by
)
goes up, RF REMOTE turns on, and the remote
control function becomes operative.
To use the Cross Remote with a previous
pairing
In the RF REMOTE indication, select ON.
• When you set RF REMOTE to ON, the transmitter will
communicate with the receiver to which it was
previously paired. To use the wireless remote control
function with another receiver, you must perform the
pairing procedure for that receiver.
• Multiple transmitters cannot be paired with the same
receiver.
• If you reset all parameters by using the FACTORY
, the pairing setting of
the transmitter is also cleared.
The following transmitter settings can be done
from the remote control:
• Transmitter name setting
• Frequency band/group/channel selection
• RF transmission power setting
• MIC/LINE setting and attenuator setting for audio input
level
• Low-cut filter setting
• Power save setting
• Resetting accumulated use time
• Audio codec mode setting
• Internal signal setting
• POWER switch lock setting
For details on menu operation, see “Setting Menus” on
page 10.
To perform remote control, the receiver must be equipped
with a control function for the setting you want to control.
For details, refer to the operating instructions supplied
with the receiver.
To cancel the Cross Remote
In the RF REMOTE indication, select OFF.
Notes on the Cross Remote
The wireless remote control function on the transmitter
uses the 2.4-GHz band and may thus be subject to
interference from other devices.
• When pairing fails (“Pairing fail” is displayed),
successful communication between the transmitter and
the receiver has not occurred within a given amount of
time. Pairing may be harder to do when another receiver
is engaged in pairing nearby.
• When it becomes hard to use the remote control, the
remote control may be improved by switching the
wireless remote control function off, then on again in the
RF REMOTE display, then re-pairing with the
transmitter (change to a channel with less interference).
Notes
Notes
