13
If the transmitter is turned off while the reference signal
function is on, the function will turn off automatically.
Using wireless remote control, this function can be
controlled from the receiver and other devices.
For details on wireless remote control function, see
“Using the Cross Remote” on page 7.
Locking the POWER switch
(POWER
SW LOCK)
The POWER switch can be locked to prevent the
transmitter from being accidentally turned off or on.
Even when the POWER switch is locked, all parts of the
transmitter other than the POWER switch remain
functional.
UNLOCK:
The POWER switch is not locked.
LOCK:
The POWER switch is locked.
When LOCK is selected, the POWER switch lock icon
appears in the display.
Using wireless remote control, this function can be
controlled from the receiver and other devices.
For details on wireless remote control function, see
“Using the Cross Remote” on page 7.
Cross Remote
(RF REMOTE)
This function must be set to allow the wireless remote
control function to be used between the transmitter and
receiver.
OFF:
Stops the wireless remote control function.
ON:
Starts the wireless remote control function with the
previously paired receiver.
PAIRING:
Executes a new pairing.
For details, see “Pairing with a receiver” on page 7.
If “RESTRICTED BY GP/CH SETTING” appears on the
RF REMOTE screen, the wireless remote control function
cannot be used. To use the wireless remote control
function, select a different transmission channel.
For details on how to change the transmission channel, see
“Setting the Transmission Channel” on page 6.
Setting the brightness of the display
(BRIGHTNESS)
Ten levels of brightness can be selected for the organic
light-emitting diode display.
The selectable settings are the following:
(Dark)
1 2 3 4 5 6 7 8 9 10
(Bright)
Automatic dimming of the display
(DIMMER MODE)
The organic light-emitting diode display can be set to dim
or turn off after a certain amount of time.
AUTO OFF:
The display turns off after 30 seconds. The
display goes on again when you press the SET, +, or –
button.
AUTO DIMMER:
The display dims after 30 seconds. The
display becomes bright again when you press the SET, +,
or – button.
ALWAYS ON:
The display stays on at the brightness
level set with the BRIGHTNESS function.
Resetting parameters to their factory
settings
(FACTORY PRESET)
All parameter settings can be returned to their factory
settings.
Holding down the SET button until a message appears
asking for confirmation. Press the + or – button repeatedly
to select YES, and then press the SET button to enter. The
transmitter parameters are reset to their factory settings.
• The setting for this function cannot be changed during
actual signal transmission. To change the setting, turn
off the power first. Then while holding down the SET
button, turn the power on. Then change the setting after
the signal transmission has stopped.
• To start signal transmission with the factory parameter
settings, turn off the power and then turn it on again.
Displaying the software version
(VERSION)
The version of the transmitter software can be displayed.
Note
Note
Notes
