2-6 E
1
Two screws
2
Feeder motor Assy
3
Tension spring
4
Feed lock
6
Feed lock
7
Feeder cam (R) Assy
5
Tension spring
Reinforcement
Feeder cam (L) Assy
Positioning hole
Side plate (R)
7
Feeder cam (R) Assy
0
Pin (ø1)
9
Pin (ø1)
8
Gear (A)
Phase adjusting of Feeder cam Assy
1) Remove each part in numerical order in the figure.
(Refer to Fig.2)
Fig.2
2) Rotate the gear (A)
8
in the direction of arrow, and pierce the
Pin (ø1)
9
through from a positioning hole on the reinforce-
ment to the feeder cam (L) Assy. (Refer to Fig.3)
3) Pierce the Pin (ø1)
0
though a positioning hole on the side
plate (R) in the state of step 2), then install the feeder cam (R)
Assy
7
. (Refer to Fig.3)
4) Pull out the two Pins (ø1)
9
and
0
, then install each part
1
to
6
in reverse order of removing. (Refer to Fig.2)
FIg.3