140
Various messages appear on the screen. Check the corresponding descriptions in the
following list to correct the problems.
General
Message
Cause and/or Corrective Actions
USB Connection Error
USB Communication Error
The Connected USB Device
is not Compatible
Bluetooth Connection Error
Bluetooth
Authentication Error
Check the Certified Status
Bluetooth
Registration Error
Check the Passkey
Bluetooth Communication
Disconnected
Bluetooth
Connection Error
Select Bluetooth Device
PPP Authentication Error
Check ID or Password
Phone Line Disconnected
Connection Error
No Response From PPP Server
Connection Error
Check Phone Line
Low Battery
Profile Error
Reset Profile
DI Customer ID Profile
Incompleted
Unable to Gain IP Address
Memory Error
Messages
A USB device is not connected correctly.
c
Connect correctly (p. 19).
• An invalid USB device is connected.
• The connection was interrupted by the USB device.
An incompatible USB device is connected.
• The Bluetooth device is too far from your camcorder.
• The Bluetooth device is busy.
Register the Bluetooth device again (p. 24).
• The entered passkey was not correct.
• The passkey transmission failed.
• The Bluetooth device is turned off.
• The Bluetooth device is too far from your camcorder.
• The Bluetooth device is not connectable.
No Bluetooth devices are registered. Register the Bluetooth device
(p. 24).
Your ID or password entered on the PPP screen during manual
setup may be wrong (p. 57).
Check the connection status.
• The telephone number entered on the PPP screen in manual setup
may be wrong.
• The Modem unit setup on the Network Options screen is wrong.
Check that the communication device is connected to the telephone
line.
The remaining power of the battery pack is not enough. Change the
battery pack or use the AC Adaptor.
Check the setup. If the settings were cleared, set up again referring to
your Setup memo (p. 149).
Check your DI customer ID or password entered on the Network
Setup screen.
IP address is not obtained automatically. The setting may be wrong
or the server may be down.
Exit the network function, then enter the network function again.