![background image](http://html.mh-extra.com/html/sony/cmt-px5/cmt-px5_operating-instructions-manual_420430067.webp)
Additional Information
67
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (see
page 7).
• Connect the aerial properly (see page 5).
• Find a place and an orientation that provide
good reception, then set up the aerial again.
If you cannot obtain good reception, we
recommend you connect a commercially
available external aerial.
• The supplied FM lead aerial receives signals
along its entire length, so make sure you
extend it fully.
• Locate the aerials as far away from the
speaker cords as possible.
• Consult your nearest Sony dealer if the
supplied AM aerial has come off the plastic
stand.
• Try turning off surrounding electrical
equipments.
A stereo FM programme cannot be
received in stereo.
• Press STEREO/MONO until “STEREO”
appears in the display.
• See “Severe hum or noise/stations cannot be
received.”, and check the aerial condition.
Cyclical static noise is heard while
recording on an MD.
• Adjust the aerial orientation and position until
the noise stops.
MD Deck
An MD cannot be inserted.
• Insert the MD with the arrow side up and the
arrow pointing toward the deck.
The controls do not work.
• Replace the MD with a new one.
• Retry the operations after “TOC” turns off.
Play does not start.
• Replace the MD.
• Remove the MD and leave the system turned
on for a few hours until the moisture
evaporates.
• Press MD
HS
to start play.
The sound skips.
• Replace the MD.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the
system, or placing them on separate stands.
When you listen to a track with bass sounds at
high volume, the speaker vibration may cause
the sound to skip.
• Insert the disc and wait for 10 to 20 minutes
with the system turned on.
Play does not start from the first track.
• Press PLAY MODE repeatedly until
“PROGRAM” and “SHUFFLE” disappear to
return to normal play.
“—OVER—” appears.
• Turn –
l/L
+ or
j/J
counterclockwise to return to the desired
playing position.
“OVER” lights up during recording.
• Set the volume of the connected component
lower.
Recording or editing was done, but the
TOC is not updated.
• MD recording and editing contents are
recorded to the MD when the MD is removed,
so make sure you remove the MD after
recording or editing (see pages 26 and 40).
Recording is not possible.
• Remove the MD and slide the tab to close the
slot (see page 26).
• Connect the optional A/V component
properly (see page 60).
• Switch to another sound source.
• Replace the MD with a recordable MD, or use
the Erase function to erase unnecessary tracks
(see pages 43 to 46).
• Start recording over from the beginning.
The sound from an MD you recorded is
too low (or too high).
• Set the volume of the connected component
lower (or higher) (see pages 39 and 51).
continued
Содержание CMT-PX5
Страница 1: ...Operating Instructions Micro Hi Fi Component System 4 231 125 21 1 2000 Sony Corporation CMT PX5 ...
Страница 78: ......
Страница 79: ......
Страница 80: ...Sony Corporation Printed in Japan ...