Sony CMT-EH25, Руководство по эксплуатации

Страница: 29 / 32

CMT-EH26/EH25.GB.3-874-279-11(1)
GB
O
thers
Specifications
Main unit
Amplifier section
European and Russian models:
DIN power output (rated):
4 + 4 watts (4 ohms at 1 kHz, DIN)
Continuous RMS power output
(reference): 5 + 5 watts (4 ohms at
1 kHz, 10% THD)
Music power output (reference):
7 + 7 watts (4 ohms at 1 kHz, 10%
THD)
Other models:
DIN power output (rated):
4 + 4 watts (4 ohms at 1 kHz, DIN)
Continuous RMS power output
(reference): 5 + 5 watts (4 ohms at
1 kHz, 10% THD)
Inputs:
AUDIO IN (stereo mini jack):
voltage 800 mV, impedance
47 kilohms
(USB) port: Type A, maximum
current 500 mA
Outputs:
PHONES (stereo mini jack): accepts
headphones of 8 ohms or more
SPEAKER: accepts impedance of
4 ohms
USB section
Supported bit rate
MP3 (MPEG 1 Audio Layer-3):
32  320 kbps, VBR
Sampling frequencies
MP3 (MPEG 1 Audio Layer-3):
32/44.1/48 kHz
To prevent a tape from being
accidentally recorded over
Break off the cassette’s overwrite
protection tab from side A or B as
illustrated.
To later reuse the tape for recording,
cover the broken tab with adhesive tape.
About a tape longer than 0 minutes
The use of the tape with more than 90
minutes of play time is not recommended
except for long, continuous recording or
playback.
Cleaning the tape heads
Use dry- or wet-type cleaning cassette
(available separately) after every 10 hours
of use, before you start an important
recording, or after playing an old tape.
Failure to clean the tape heads can cause
degraded sound quality or an inability
of the unit to record or play tapes. For
details, refer to the instructions of the
cleaning cassette.
Demagnetizing the tape heads
Use a demagnetizing cassette (available
separately) after every 20 to 30 hours
of use. Failure to demagnetize the tape
heads can cause an increase in noise, a
loss of high frequency sound, and an
inability to completely erase tapes. For
details, refer to the instructions of the
demagnetizing cassette.
Break off
the cassette
tab
Continued
