Sony CHP-411D, Руководство по эксплуатации

Страница: 8 / 28

8 (E)
Optical characteristics
Projection system 3 picture tubes, 3 lenses, Horizontal
inline system, Rear projection type
Picture tube 7-inch monochrome tubes, with
coolant sealed (5.5-inch raster size)
Projection lens F1.1/77mm
Projected picture size
RVP-411DS/411DMS: 41 inches
measured diagonally
Luminance RVP-411DS/411DMS with the
VPS-411RF screen:
ANSI (cd/m
2
)
1)
280 cd/m
2
Peak 600 ft-L (2056 cd/m
2
)
Light output ANSI lumen 1)
110 lm
Electrical characteristics
Input signal Analog RGB signal
When an optional PWB-411D
video input board is attached:
analog color difference signal,
PAL, SECAM, NTSC and NTSC
4.43
Resolution 800
×
560 dots (RGB input at 31.25
kHz/50 Hz)
Frequency range 30 MHz, –3 dB
Input frequency 31.25 kHz/50 Hz/1:1, 31.25 kHz/
100 Hz/2:1, 31.5 kHz/
60 Hz/1:1, 31.5 kHz/120 Hz/2:1
(Horizontal frequency/Vertical
frequency/Interlace ratio)
allowance ±1%
15.625 kHz/50 Hz/2:1, 15.75 kHz/
60 Hz/2:1 (when an optional PWB-
411D video input board is used)
Test signal
2)
Cross hair/hatch (fine)/diagonal/
circle/dot/H/ME/window/all white/
black
Specifications
Inputs RGB signal
R, G, B: 0.7Vp-p±2dB, 75 ohms
terminated
G signal with sync input:
1.0Vp-p±2dB, 75 ohms
terminated, sync negative
HD, VD: 1.0–4.0Vp-p, 75 ohms
terminated, positive/negative
SYNC: composit sync input, 1.0–
4.0Vp-p, 75 ohms terminated,
positive/negative
Y, R-Y, B-Y signal (when an
optional video input board is
attached)
Y: 1.0Vp-p±2dB, 75 ohms
terminated, sync negative
R-Y, B-Y: 0.7Vp-p±2dB, 75 ohms
terminated
Video signal (when an optional
video input board is attached)
Composite video input: BNC
connector, 1.0Vp-p±2dB, 75
ohms terminated, sync negative
Y: BNC connector, 1.0Vp-p±2dB,
75 ohms terminated, sync
negative
C: BNC connector, burst level,
0.286Vp-p±2dB, 75 ohms
terminated (NTSC)
0.3Vp-p±2dB, 75 ohms
terminated (PAL)
REMOTE IN: D-sub 9-pin
connector (See “Signal
assignment” on page 9 (E).)
CONTROL S IN: minijack
ABL LINK IN: minijack
Outputs REMOTE OUT: D-sub 9-pin
connector (See “Signal
assignment” on page 9 (E).)
CONTROL S OUT: minijack
ABL LINK OUT: minijack
.......................................................................................................................................................................................................
1) ANSI lumen and cd/m
2
are measuring methods of American National Standard IT 7.215.
2) Inputting the 15 kHz sequential scanning signal may affect the test signal.