26
Error displays/Messages
The sound skips.
• Installation is not correct.
t
Install the unit at an angle of less than 45° in a
sturdy part of the car.
• Defective or dirty disc.
The operation buttons do not function.
The disc will not eject.
Press the RESET button (page 6).
Radio reception
The stations cannot be received.
The sound is hampered by noises.
The connection is not correct.
t
Connect a power antenna (aerial) control lead
(blue) or accessory power supply lead (red) to the
power supply lead of a car’s antenna (aerial)
booster (only when your car has built-in FM/AM
antenna (aerial) in the rear/side glass).
t
Check the connection of the car antenna (aerial).
t
If the auto antenna (aerial) will not go up, check the
connection of the power antenna (aerial) control
lead.
t
When the DSO mode is on, the sound is sometimes
hampered by noises.
Set the DSO mode to “off” (page 17).
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
Automatic tuning is not possible.
• Setting of the local seek mode is not correct.
t
Tuning stops too frequently:
Set “Local on” (page 19).
t
Tuning does not stop at a station:
Set “Local off” (page 19).
• The broadcast signal is too weak.
t
Perform manual tuning.
During FM reception, the “ST” indication
flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t
Set “Mono on” (page 19).
An FM program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
t
Set “Mono off” (page 19).
USB playback
You cannot play back items via a USB hub.
This unit cannot recognize USB devices via a USB
hub.
Cannot play back items.
A USB device does not work.
t
Reconnect it.
The USB device takes longer to play back.
The USB device contains files with a complicated tree
structure.
A beep sounds.
During playback, the USB device has been
disconnected.
t
Before disconnecting a USB device, make sure to
stop playback first for data protection.
The sound is intermittent.
The sound may be intermittent at a high-bit-rate of
more than 320 kbps.
Checking
The unit is confirming the connection of a USB device.
t
Wait until confirming the connection is finished.
Error
*
1
• The disc is dirty or inserted upside down.*
2
t
Clean or insert the disc correctly.
• A blank disc has been inserted.
• The disc cannot play due to a problem.
t
Insert another disc.
• USB device was not automatically recognized.
t
Reconnect it again.
• Press
Z
to remove the disc.
Failure
The connection of speakers/amplifiers is incorrect.
t
See the installation/connections manual of this
model to check the connection.
Hubs Not Supported
USB hub is not supported on this unit.
Load
The CD changer is loading the disc.
t
Wait until loading is complete.
Local Seek +/–
The local seek mode is on during automatic tuning.
NO Device
(SOURCE)
is selected without a USB device
connected. A USB device or a USB cable has been
disconnected during playback.
t
Be sure to connect a USB device and USB cable.
NO Disc
The disc is not inserted in the CD changer.
t
Insert discs in the CD changer.
NO Magazine
The disc magazine is not inserted in the CD changer.
t
Insert the disc magazine in the CD changer.
NO Music
The disc or USB device does not contain a music file.
t
Insert a music CD in this unit or an MP3 playable
CD changer.
t
Connect a USB device with a music file in it.
Not Supported
The connected USB device is not supported.
t
For details on the compatibility of your USB
device, visit the support site.
