2
Precautions
On safety (Refer to the supplied
“WARNING”.)
Should any solid object or liquid fall
into the cabinet, unplug the recorder and
have it checked by qualified personnel
before operating it any further.
On power sources
• Before operating the player, check that
the operating voltage of the player is
identical with your local power supply.
The operating voltage is indicated on
the nameplate at the rear of the player.
• If you are not going to use the player
for a long time, be sure to disconnect
the player from the wall outlet. To
disconnect the AC power cord, grasp
the plug itself: never pull the cord.
• AC power cord must be changed
only at the qualified service shop.
On condensation
If the player is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may condense
on the lenses inside the player. Should
this occur, the player may not operate
properly. In this case, remove the CD
and leave the player turned on for about
an hour until the moisture evaporates.
On cleaning
Clean the cabinet, panel and controls with
a soft cloth slightly moistened with a
mild detergent solution. Do not use any
type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.
If you have any questions or problems
concerning your player, please consult
your nearest Sony dealer.
WARNING
Notice for the Customers in the
United Kingdom
IMPORTANT
The wires in this mains lead are
coloured in accordance with the
following code:
Blue:
Neutral
Brown:
Live
As the colours of the wires in the
mains lead of this apparatus may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
The wire which is coloured blue must
be connected to the terminal which is
marked with the letter N or coloured
black.
The wire which is coloured brown
must be connected to the terminal
which is marked with the letter L or
coloured red. Do not connect either
wire to the earth terminal in the plug
which is marked by the letter E or by
the safety earth symbol
Y
or coloured
green or green-and-yellow.
To prevent fire or shock hazard,
do not expose the unit to rain or
moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing
to qualified personnel only.
About This Manual
Conventions
•
Controls in the instructions are those on
the player, these may, however, be sub-
stituted by controls on the remote that are
similarly named or, when different, ap-
pear in the instructions within brackets.
•
The following icons are used in this
manual:
Z
z
Indicates a procedure that
requires use of the remote.
Indicates tips for making
the task easier and hints.
INFORMATION
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses, and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications.
However, there is not guarantee that
interference will not occur in a
particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to try
to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
The laser component in this product
is capable of emitting radiation
exceeding the limit for Class 1.
This symbol is intended to alert the
user to the presence of uninsulated
"dangerous voltage" within the
product's enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature
accompanying the appliance.
This appliance is classified as a CLASS 1 LASER
product.
The CLASS 1 LASER PRODUCT MARKING is
located on the rear exterior.
Содержание CDP-D11
Страница 24: ...OTHERS 24 Printed in Japan ...
