28
The Connection/Power Menu
The Connection/Power Menu
The Connection/Power menu is used for setting for the connections and power.
Items
Item descriptions
LAN Settings
IP Address
Setup
*9
Auto (DHCP):
The IP address is assigned automatically from the
DHCP server such as a router.
Manual:
To specify the IP Address manually.
WLAN Settings
*10
WLAN
Connection
*8
On/Off:
Set the wireless output of the USB wireless LAN module (not
supplied) to On/Off.
Access Point
Setup
Auto/Manual
*11
:
Set the access point automatically or manually.
Input-A Signal Sel.
Auto/Computer/Video GBR/Component:
When set to “Auto,” selects
the type of video signal input automatically when “Input-A” is selected.
*1
ECO
Lamp Mode
High/Standard/Low/Auto
*5 *7
:
When set to “High,” the image
becomes brighter, and power consumption becomes higher. When set to
“Low,” power consumption is minimized; however, the image will be
darker. When set to “Auto,” brightness is adjusted automatically
according to image content. Dark images are projected with brightness
adjusted, leading to energy-saving. Bright images are projected
brightly, without adjusting brightness.
Auto Power Saving
With No Input
Lamp Cutoff:
The lamp turns off automatically and power
consumption is reduced if no signal is input for more than 10 minutes.
The lamp lights again when a signal is input or any key is pressed. In
Lamp Cutoff, the ON/STANDBY indicator lights in orange. (page 48)
Standby
*
6
:
If no signal is input to the unit for more than 10 minutes,
the power turns off automatically, and the unit enters standby mode.
Off:
You can deactivate the With No Input.
With Static
Signal
Lamp Dimming
*4 *5 *7
:
If an image does not change for about 10
seconds, lamp output is gradually reduced (approximately 10% to
15%*
3
) from that set in the Lamp Mode. Automatically the lamp slowly
darkens to approximately 30% of its lamp output according to the
selected time (with no change to input signal) “
5
,” “
10
,” “
15
,” “
20
”
minutes or “
Demo
.,” While dimming the lamp, the message “Lamp
Dimming” appears. If you select “Demo.,” the image will start to
darken about 40 seconds later. When any change in signal is detected,
or an operation (remote control or control panel) is performed, normal
brightness is restored.
Off:
You can deactivate the With Static Signal.
Standby Mode*
2
Standard/Low:
When set to “Low,” lowers power consumption in
Standby mode.
