Sony Betacam SX DNW-A22, Руководство по обслуживанию

Страница: 55 / 286

2-29
DNW-A22/A22P
2-16. Setup Menu (F-series)
2-16-2. F-Series Items
No. ITEM Settings Description
F01 AUDIO NR IN SP
[ON]
n
MODE SW This item is used exclusively for analog Betacam longitudinal audio playback
adjustment for 625/50 system.
After adjustment is completed, return to the factory setting “ON”.
Turns on and off the Dolby NR when using a metal tape.
ON: Dolby NR is turned on usually
SW: Dolby NR switch is turned on and off depending on the setting of the sub
control panel
n
When using an oxide tape, follows the sub control panel switch setting regardless
of the above setting.
F02 EMERGENCY TAPE
[ENA]
n
PROTECTION DIS This item is used exclusively for servo and mechanical adjustment.
After adjustment is completed, return to the factory setting “ENA”.
Selects whether emergency tape protection operation is enabled or not when VTR
detects error in tape transport mechanism.
ENA: Tape protection operation is enabled
DIS: Tape protection operation is disabled
F13 TRACKING CONTROL
[OFF]
n
VIA SEARCH DIAL ON This item is used exclusively for video tracking adjustment.
After adjustment is completed, return to the factory setting “OFF”.
Turns on and off the tracking control operation with search dial.
OFF: Tracking control with SHUTTLE dial is not activated
ON: Tracking control becomes active when turning SHUTTLE dial in PLAY mode
F16 DEVICE TYPE
[0]
Determines response data to 9-pin remote command DEVICE TYPE REQUEST
MODIFY:0H 1 (00h, 11h).
| 0: Returns the original device type data of the unit
FFFF Except 0: Returns the set values as they are:
The higher-order two digits are for DATA-1
The lower-order two digits are for DATA-2
n
Any selection of the above does not influence the whole VTR operation including TTP.
If this item is set to values other than the factory setting “0”, the operation
of the unit is not ensured under the 9-pin remote command control.
F34 STOP PINCH OFF TIME 0 M Specifies the time at which the pinch ON condition is kept even if the PB operation
[5|M]
is completed in the SX tape PB mode. The time is usually set to “5 M”. When
10 M “0 M” is set, the pinch is turned off as soon as the PB operation is completed.
15 M
20 M
n
When the pinch is turned off, it takes a few seconds to output image and sound
signals during PB operation of the next time.