Sony BC-M50, Руководство по обслуживанию

Страница: 12 / 30

1-6 (E)
BC-M50
28
Location and Function of Parts
Location and Function of Parts
1 POWER switch and indicator
Once you turn this switch ON, power
is supplied and the associated
indicator lights up. The battery packs
are charged in order (the one on the
charge indicator 1 side first, then the
other on the charge indicator 2 side).
2 Refresh button
Attach a nickel metal hydride battery
pack to the battery pack attachment
section 1 and press this button for
about a second. While the battery
pack is being refreshed, the charge
indicator flashes in red.
Note
Be sure to attach the battery pack to be
refreshed to the battery pack
attachment section 1. The battery
pack attachment section 2 is not
capable of refresh function.
3 Leg
Before charging a battery pack,
pull out the leg as shown in the
figure to stabilize the unit during
charging.
To return the leg to its original
position, grasp the handle and pull
down while rotating in the
opposite direction.
Grasp the illustrated handle and pull out
while rotating.
2
1
1
POWER switch and indicator
3
Leg
4 Battery pack attachment sections and
charge indicators 1/2
5 Carrying handle
6
AC IN connector
7 Plug holder
receptacle
Release
button Release
button
2 Refresh
button
29
4 Battery pack attachment sections
and charge indicators 1/2
Attach BP-L40/L40A/L60A/L90A/
M50/M100 battery packs.
When you detach a battery pack, pull
it up, holding the release button in.
The charge indicators indicate the
progress or result of charging by
flashing or lighting in red, orange and
green.
Flash in orange: Charge in progress
(charged 0% to 80%)
Light in orange (only when
charging lithium-ion battery
packs): Charge wait (charged
80% and the other battery pack is
now being charged).
This status arises only when you
attach two lithium-ion battery
packs.
Flash in green (only when
charging lithium-ion battery
packs): Charge in progress
(charged 80% and over)
Light in green: End of charging
Flash in red and green: One of the
following conditions exists.
• Before charging, the output
voltage of the charger was some
value other than the specified
voltage.
• Once charging started, the
battery voltage did not rise to
the charge voltage within a
specified period.
• Once charging started, the
battery connector voltage rose
above the specified voltage.
• Once charging started, the
battery connector voltage
dropped below its initial value.
If any of the above conditions occur,
try recharging the battery pack two or
three times. If the condition persists,
the battery pack is likely defective and
should be replaced.
The indicators also flash in red and
green while charging the nickel metal
hydride battery packs in the following
cases:
• The BC-M50 failed to detect the
presence of the battery pack.
• The temperature of the battery pack
has risen to 60°C (140°F) or higher
during charging.
If you attach a battery pack not
supported by this unit, the indicators
will also flash in red and green.
5 Carrying handle
Pull out to carry this unit.
6 AC IN (AC power input)
connector
Used to connect the charger to an AC
outlet with an optional AC power
cord.