Installation Instruction
,
Electrical
1/000 21-2/FEA 209 544/103 A
©
Sony Ericsson Mobile Communications AB
6(9)
3.2.2
Sony Ericsson Programming Interface – SEPI
The Sony Ericsson Programming Interface (SEPI) (9) is delivered with the necessary software
and instructions for installation.
3.2.3
Sony Ericsson Programming Interface (SEPI) Cable
The Sony Ericsson Programming Interface Cable (10) is the interface between the Sony Ericsson
Programming Interface (SEPI) (9) and the phone.
1.
Connect this cable between the Sony Ericsson Programming Interface (SEPI) and the phone.
3.2.4
Battery Charger
A battery charger must be connected to the Sony Ericsson Programming Interface Cable during
calibration.
1.
Connect the plug of the battery charger (POS-27) into the plug of the Sony Ericsson
Programming Interface Cable (POS-10).
2.
Ensure the battery charger (POS-27) is connected to the line voltage.
3.2.5
USB cable
The USB A-B Plug-Plug cable (43) is the interface between the computer and the Sony Ericsson
Programming Interface.
1.
Connect this cable between the Sony Ericsson Programming Interface (SEPI) (9) and the
computer (96).
3.2.6
Test Instrument
The test instrument (POS-76) used for SERP must be a Sony Ericsson approved instrument with
all required software and hardware options installed. Refer to the Z530 Equipment List, Electrical
for the list of approved test instruments.
The test instrument installation and operation should be in accordance with the manufacturer’s
instructions.
3.2.7
GPIB Card and Cable
1.
Install the GPIB card (POS-83) in the computer according to the instructions supplied by the
manufacturer.
2.
Use the GPIB cable (POS-84) to connect the GPIB card (POS-83) to the test instrument
(POS-76).
