Sonus Faber Homage Vox, Руководство пользователя, Страница: 10 / 38

ENGLISH
OPENING THE PACKAGING
ADJUSTING THE ANGLE
All Sonus faber’s speakers have been packed in order to carefully protect the contents and at the same time make
unpacking simple.
We suggest, however, following these recommendations:
• Keep all packaging for any future transport;
• Do not wear watches, bracelets, rings etc. in order to avoid scratching the speakers and their precious finishes
when unpacking; Protect the speakers from any metal finishes present on the clothes you are wearing, such as zips,
buttons, belt clasps, etc.;
• Open the packaging following the instructions printed on it.
Specific indications:
• Place the package on the ground, respecting the words UP and DOWN that appear on the cardboard;
• Open the top of the external packaging (fig. 1);
• Cut the bag and open the top of the internal packaging (fig. 2 and 3);
• Extract the accessories box (fig. 4);
• Remove the top layer of protective Stratocell (fig. 5 and 6);
• Remove the speaker from the packaging (fig. 7).
IMPORTANT: Two people are needed to remove the speaker from its packaging.
To prevent harming people and/or damaging the speaker, we advise the correct positions as shown in
figure 7.
Packaging contents:
Inside the packaging, in addition to the speaker, you will also find an accessories box that contains:
• Frame with elastic strings;
• Microfiber cloth;
• Cleaner;
• Fabric dust sheet.
The speaker can be angled using the support base it is mounted on.
To modify the angle follow these instructions:
• Rotate the speaker 90° and position it on one side, being careful to protect it using the supplied cloth (fig. 8 and 9);
• Loosen the knobs below the speaker (fig. 10);
• Delicately change the position of the base until the required angle is reached (fig. 11), then solidly tighten the knobs;
• Reposition the speaker on its support base (fig. 8).
To adapt the speaker to your listening requirements, the base can be angled up to 180° (refer to fig. 12a and 12b for
the two base positioning solutions).
To do this, follow these instructions:
• Remove the base by unscrewing and removing the knobs indicated in fig. 10 completely;
• Rotate the base 180°;
• Re-assemble the base, tightening and solidly fixing the knobs on the speaker;
• Reposition the speaker on its support base (fig. 8).