Tel: +44 (0)1732 861200
-
E
-
mail: [email protected]
-
Web: www.sontay.com
© 2017 Sontay Limited. All rights reserved
RF
-
LW
-
HUB
IoT LoRaWAN to BACnet IP/Modbus TCP/MQTT Hub
Issue Number 7.0
10/08/2022
Four Elms Road
-
Edenbridge
Kent
-
TN8 6AB
-
UK
17 of 27
•
Check that the ETH1 or ETH2 LED lights up
•
Connect all equipment to the switch via the Ethernet cables.
To configure each one of the equipment:
•
Using the technical documentation of the equipment, find its IP address and TCP port (and if necessary, for some devices, the address
of the slave "Slave ID").
•
If the equipment does not have an IP address, assign one to it, 192.168.1.1 for the first device, then 192.168.1.2 for the second device,
192.168.1.3 for the third device, and so on.
•
Write down the IP address and TCP port (and if necessary, for certain devices, the address of the Slave ID), the brand and model of
the equipment, and any information that allows it to be identified. This information will be necessary for the installation configuration
and to retrieve data.
-
From the BMS software, perform an extract of the available properties: list the data types provided by the different devices to
which the BMS has access.
-
If it is impossible to retrieve this information, get the IP address and TCP port (and if needed, for some devices, the slave
address (Slave ID), the brand, and model of the equipment, and extra identifying information. This information is necessary for
the installation configuration and to retrieve data.
•
In the case of a BACnet IP network
-
Write down the BACnet port of the network. This information will be necessary for the installation configuration and to retrieve
data.
