SonoSite V-UNIVERSAL STAND, Руководство пользователя

Страница: 8 / 96

6
To connect AC power
™
Connect the following cords. See Figure 1 on page 3.
• DC power cord
• System AC power cord
Removing the ultrasound system
To remove the ultrasound system
1
Support the ultrasound system, and loosen the screw in each of the four corners of the mounting
plate. If necessary, use a Phillips screwdriver. See
Figure 3 .
Supporting the system ensures that it doesn’t drop when loosened.
2
Lift the system off the stand.
The system lifts off the two mounting-plate pegs.
To remove the transducer holder
™
Using a Phillips screwdriver, loosen the four screws on the back of the transducer holder. See
Figure 2 .
Using the printer
Printer
The NanoMaxx and S Series ultrasound systems support the printer.
For specific information on using the printer, including warnings and cautions, see the manufacturer’s
operating instructions.
To configure the system for the printer, see the ultrasound system user guide. You configure the
system on the Connectivity setup page.
To connect the printer, see the V-Universal Stand assembly instructions.
To print the screen
Note: Test the printer before a patient exam to ensure that all connectivity is correct.
™
Use the controls on the printer for printing images. Follow the manufacturer’s instructions.
You can also save images and print them from the patient list. For instructions, see the ultrasound
system user guide.
WARNING: To avoid the risk of electrical shock or injury, do not connect more than one
peripheral at a time.
Caution: To avoid damaging the system, use only peripherals recommended by SonoSite
with the ultrasound system.