Sonoro SO-410, Руководство по эксплуатации

Страница: 42 / 252

42 © sonoro audio GmbH 2016
19 Troubleshooting
Malfunctions can occur with any electrical equipment. This is not
necessarily due to a device defect. As such, you should check the
following table to see if you can eliminate the problem yourself.
Malfunction Possible cause Solution
No power Power cable is not
properly connected. Connect the power
cable properly.
No response from
the device There is an error in
the device. Disconnect and
reconnect the power
plug. Then turn the
device on again.
Remote control does
not work, or only
works sporadically Distance to the
device is too large. Reduce the distance
between the remote
control and device.
Battery is empty. Replace the battery.
No sound or poor
sound Sound is turned off.
Device is not set to
the correct playback
mode. Select another
playback mode.
FM/DAB or Internet
reception is poor.
FM/DAB antenna
or check the Wi-Fi
connection.
There is radio
interference. Keep the device away
from other electronic
devices.
Alarm does not work. Alarm is not
activated. Activate the alarm.
Alarm volume is set
too low. Increase the alarm
volume.
Insufficient Wi-Fi
signal strength The router is too far
or blocked. Place the device
closer to the router
of the Wi-Fi antenna.