Sonny's Pendulum 807W Combo, Руководство пользователя

Страница: 19 / 21

Owner
’s Manual
Pendulum 807W Combo
© 2021 SONNY’S The CarWash Factory
®
. All Rights Reserved SonnysDirect.com
This document is confidential and proprietary to SONNY’S and cannot be used, disclosed or
Page 19 of 21
published without prior written consent. Content, prices, and availability subject to change without notice.
QUICK FIX - Pendulum 807W Combo.docx
– Rev 2021-A
*PREVENTIVE MAINTENANCE*
DAILY
1) During Opening Checks, check for leaks around hydraulic hoses and fittings. Repair any
hydraulic leaks immediately. (Omni Top option)
2) Check spray pattern from nozzles and clean any dirty nozzles.
3) Operational Checks
a) Check for leaks around hoses and fittings. Repair any serious water or air leaks
immediately.
b) General examination of operation, listening for any unusual noises.
c) Observe fluid level in reservoir. If low, add fluid or if contaminated, drain and replace.
(Omni Top option)
d) Inspect Mitter cloth for cuts, grease, or oil. Remove and repair, or replace, any cloth
panel if any of these conditions are found.
e) Check for any oil leaks around the gear reducer, and repair if needed.
WEEKLY
1) Check all nozzles for wear and replace if necessary.
2) Perform a close inspection of operating mechanisms and hoses for problems.
3) Grease the rod end on both ends of the drive arms.
MONTHLY
1) Inspect all UHMW bearings for wear. Replace if necessary.
2) Inspect all UHMW rollers on the push arm for wear.
3) Inspect all split collar couplers for wear and replace as needed.
4) Inspect all hardware and fittings for tightness and clean the entire assembly thoroughly.
5) Grease all pivot point bearings.
ANNUALLY
1) Drain, purge, and refill hydraulic system. (Omni Top option)
2) Drain, flush clean, and refill oil in the speed reducer with:
a) SAE 90 gear oil for ambient temperatures of 15 degrees Fahrenheit through 50
degrees Fahrenheit.
b) SAE 140 gear oil for ambient temperatures of 50 degrees Fahrenheit through 120
degrees Fahrenheit.
DO NOT OVERFILL !! Remove the speed reducer case plug just above the output shafts
and fill to that level.