Technical Specification
Sonifex HY-02 User Handbook
15
Technical Specification
HY-02 Connection Details
All of the connections are located on the rear of the HY-02 :
Line Input
The line input is an XLR 3 pin female connector (XLR-3-31, 10k ohm balanced floating).
Pin 1 : Screen
Pin 2 : Phase
Pin 3 : Non-phase
Mic Input
The mic input is a stereo jack female connector (200 ohm balanced floating).
Tip : Phase
Ring : Non-phase
Sleeve : Screen
Line Output
The line output is an XLR 3 pin male connector (XLR-3-32, 50 ohm balanced floating).
Pin 1 : Screen
Pin 2 : Phase
Pin 3 : Non-phase
Handset
This is the connection for a telephone handset and is a BT605A socket (accepts standard BT telephone plug).
NTTP Port
This is the telephone line connection and is an NTTP BT6/502 cord plug which plugs into a standard BT line jack socket.
The telephone line is connected via the white and red wires on the connector (the latch is adjacent to Pin 6).
Pin 1 : Not used
Pin 2 : White wire, BT line A
Pin 3 : Green wire, Earth recall
Pin 4 : Blue wire, Ringer
Pin 5 : Red wire, BT line B
Pin 6 : Not used
Remote
The HY-02 is equipped with a 5 way IP40 socket (678 series) which is assigned as follows :
Pin 1 : Lamp Hybrid Unit 1
Pin 2 : Divert Switch (Line Connect), Hybrid Unit 1
Pin 3 : Common
Pin 4 : Lamp Hybrid Unit 2
Pin 5 : Divert Switch (Line Connect), Hybrid Unit 2
The mating connector for this remote is supplied with your HY-02 unit. Check your packaging if you can’t find it as often,
this is thrown out when unpacking.
MIC.
MIC.
SERIAL NO. HY
POWER 1
POWER 2
REMOTE
100mA ; 20 x 5mm
SERIAL NO.
HY
DC
POWER
OUTPUT
INPUT
HANDSET
LINE
NTTP
PORT
SERIAL NO.
HY
DC
POWER
OUTPUT
INPUT
HANDSET
LINE
NTTP
PORT