VOLUME CONTROL
The
buttons on the front panel are the master volume controls for
the i-Fusion system. Press and hold
“
+
”
to increase the volume and then
“
-
”
to decrease the volume. The volume will start at 30% maximum
volume position every time you re-start the i-Fusion system. This will
avoid disturbing others when booting it up. As with all speaker systems,
distortion may occur at high volumes. If so, turn the volume down.
POWER OFF
When not in use and to minimize power consumption, please set the
power switch to the “OFF” position
. Please note that the i-Fusion
has an “AUTO SHUT-DOWN (STANDBY) function which prevents excess
power consumption during idle play.
AUTO SHUT-DOWN (STANDBY):
When the power switch is set at the
“
AUTO ON
”
position, the i-Fusion
system will shut down automatically and goes into standby mode if an
audio signal is not detected within 5 minutes. The LED on the power
switch will then turn to red
The LED will automatically turn to
green
when an audio signal is detected and the i-Fusion system
will automatically power on. Power consumption will be reduced in this
“standby” mode, but we suggest that you shut down the i-Fusion system
completely when not in use for an extended period of time to save battery
life.
DATA TRANSFER
Note that you can download and upload music while your iPod is docked in
the i-Fusion’s docking station, using the iPod Dock Connector to Fire Wire
Cable that came with your iPod. Simply plug that cable into the port
located on the left side of the i-Fusion, and plug the other end into your
computer. Follow the instructions that were included with your iPod to
download, upload, and manage your music.
BUILT-IN LITHIUM ION BATTERIES
1. The i-Fusion system uses a rechargeable built-in 8.4V @2000mAH
Lithium ion battery.
2. A. Prior to your first use of the i-Fusion powered off of the Lithium ion
battery, you must
fully
charge the battery. Plug in the [email protected] AC
into an AC wall outlet and insert the barrel connector at the end of
the adapter cable into the socket marked
on the side of i-
Fusion system. A first time full charge will take 6-8 hours.
B. To recharge, connect the AC power adapter as described above. A
full recharge will take 4-6 hours. With the iPod docked, both the
battery and the iPod will be recharged simultaneously, whether the i-
Fusion system is operating or not. Alternatively, using the original iPod
30 PIN cable connected to the 30 Pin input jack on the left side of the
i-Fusion case, the iPod can be charged by itself and data can be
transmitted from your computer or laptop.
3. The i-Fusion system has a row of LED lights that serve as battery life
indicators.
high power
moderate power
slight power
WARNING: charge required:
