Sonic Electronix C1-690, Руководство пользователя

Страница: 7 / 12

7
<
OR
>
Stud bolts are provided in two lengths to accommodate different panel thicknesses.
10 mm length 25 mm length
DIAGRAM E:
Flush-Mount Tweeter Installation
FLUSH-MOUNT INSTALLATION
1) Detach the preinstalled surface-mount
fixture by inserting a small flat screwdriver
into the slots behind the tweeter flange
and carefully pry open to release.
2) Remove the vehicle panel and check the desired
mounting location to ensure that there is adequate
clearance behind the panel for the tweeter’s
magnet structure and mounting hardware.
3) Carefully cut a 1-3/4-inch (44 mm) diameter hole
in the vehicle panel. This will achieve a snug fit and
allow the tweeter flange to conceal the cut line.
4) Select a suitable length stud bolt for your panel’s
thickness and screw its short end into the rear of the
tweeter using the fixed M4 nut to tighten.
5) Insert the tweeter from the front of the panel (do
not attach the spring clip at this time).
6) Attach the spring clip from behind the panel using
the supplied M5 nut and tighten by hand until the
tweeter is tight on the panel. Do not overtighten.
8) Connect the tweeter’s wires to the wire leads from
the crossover, observing correct polarity.
9) Re-install the vehicle panel, taking care to
route the new wiring so as not to interfere
with any vehicle mechanisms (window
mechanisms, for example).