Sonic Electronix C1-690, Руководство пользователя

Страница: 5 / 12

5
TWEETER INSTALLATION
C1 tweeters have been designed for surface
or flush-mounting. Before choosing a method,
carefully inspect the desired mounting location
to determine which method will work best.
Surface-Mount : uses the supplied surface-mount
fixture and requires the drilling of three holes (one
for the wires and two for the mounting screws). This
application is useful when mounting the tweeters to a
panel that has insufficient clearance behind it for the
tweeter’s magnet structure.
Flush-Mount : yields a custom-installed appear-
ance and requires a 1-1/2-inch (38 mm) diameter hole
to be cut in the vehicle panel, with at least 0.40-inch
(10 mm) of clearance behind the mounting surface
for the tweeter and up to 1.45-inch (37 mm) for the
stud bolts used to mount each tweeter.
TWEETER PROTECTION
The C1 crossover networks are equipped with
an advanced electronic tweeter protection circuit
designed to minimize the possibility of tweeter
failure. This electronic device monitors current going
to the tweeter and will disconnect the tweeter from
the signal when it senses overload. Should this occur
while listening to the audio system, simply reduce the
volume for a few seconds and the protection circuit
will reset itself automatically.
CROSSOVER NETWORK INSTALLATION
The crossover networks supplied with your C1
System should be installed in a dry location inside
your vehicle. DO NOT INSTALL THEM INSIDE
OF A DOOR! Doors often get wet on the inside,
which can damage your crossover networks and
could potentially damage your entire sound system.
Use plastic cable ties or a similar fastener to securely
mount each crossover to avoid coming loose in the
event of a collision, sudden jolt or repeated vibrations
during normal use. Make sure that your mounting
location will not cause damage to wiring or any other
vital component of your vehicle.
TWEETER CONNECTIONS
Run the wire leads from the crossovers to
the tweeter mounting locations and to the
speaker/amplifier outputs. Then connect the
harness wire leads to the speaker/amplifier
outputs and tweeters, observing correct
polarity. See Diagram C below for details.
WA R N I N G
!!
It is absolutely vital that your component tweeter
is connected, as shown in Diagram C. Failure to
connect the tweeter as shown will result in damage
which is NOT covered under warranty. Only use
in-line filters clearly marked “C1-100cthp”.
From Woofer
or Amplifier
Tweeter Crossover
Tweeter
DIAGRAM C:
Tweeter / Crossover Wiring