Electrical Connection
Many vehicles are pre-fitted with ISO connectors behind the dash,
including all the electrical cabling for a car radio. In such cases, the
connections fitted to the vehicle can be directly plugged into the car radio
connectors. Should your car not be pre-fitted with these connectors, we
strongly advise you to obtain the ISO wiring loom fitted with the male
connector for connection to your car radio either from a specialist shop or
from the concessionaire for your vehicle. Once obtained, you will only
need to connect your loudspeakers and the power supply to the ISO
connector, following connection instructions provided with same.
CAUTION:
Make sure your car battery is a 12 volt (6 filler caps) negative ground
system (if not, a converter will be necessary).
Before starting wiring connections, disconnect the power supply by
removing the fuse box.
Connect the power wire to one of the extra terminals of the fuse box.
Connect the black ground wire to a metal part of the car. It is
important to make good contact.
Make other wiring connections as shown
Replace the fuse in the yellow power lead wire.
WARNING:
INCORRECT WIRING OR OPERATION WILL VOID THE
WARRANTY OF THIS UNIT.
THE ISO CONNECTOR MUST NOT BE CUT.
THE UNIT HAS 2 SEPARATE AMPLIFICATION STEPS. WHEN
TWO SPEAKERS ARE CONNECTED DO NOT CONNECT
TOGETHER THE WIRES BUT CHOOSE FRONT OR REAR.
THE RED WIRE MUST BE CONNECTED BY CAR IGNITION
KEY IN ORDER TO AVOID THAT CAR BATTERY BECOMES
WEAK WHEN THE CAR WILL BE NOT USED FOR LONG
PERIOD.
Back Panel Drawing
RUSX123 Wiring Diagram
Page 8
Page 7
