Sonance Navigator K2, Руководство пользователя

Страница: 15 / 106

Chapter 2 • Introduction
7
IR RECEIVER
This button displays a window that allows you to enable or disable the
infrared receiver. The infrared receiver is used to relay commands from a
wireless infrared remote control near the K2 back to the device being
controlled.
The default setting for this feature is off.
It is recommended
that this feature be turned off if not needed. Electronic and light noise in the
room where the K2 is installed can interfere with the IR commands. The
Signal bar at the top of the window shows you what the IR receiver is
detecting – it turns dark in response to infrared energy that is present. Press
the
OK
button in the window to close.
BEEPER
This button displays a window that allows you to turn the audible beep on
or off. The beeper provides feedback that a button was pressed. Press the
OK
button in the window to close.
TIME OUT
This button displays a window that allows you to adjust the amount of time
the unit waits before power down after the last button press. The time is
variable from 1 second to 60 seconds (default is 10 seconds). Press the
arrows to the left or right of the
Time Out
setting to adjust the time. Press
the
OK
button in the window to close. The backlight level during power
down can be adjusted from a medium backlight level to completely off to
minimize power consumption on the system.