4
22. Always cut off power from the heater before relocating it!
23. Lift only by its plastic carrying handle!
24. Do not locate the appliance directly below or next to a wall outlet.
25. If any irregular operation is detected (e.g., unusual noise or burnt odor from unit), immediately switch it off and
remove the power plug.
26. Make sure that no foreign objects or liquid can enter the unit through the openings.
27. Protect from dust, humidity, sunlight and direct heat radiation.
28. Power off the unit by unplugging it from the electric outlet prior to cleaning.
29. Do not touch the unit or the power cable with wet hands!
30. The appliance may only be connected to properly grounded 230 VAC/50 Hz electric wall outlets.
31. Unwind the power cable completely.
32. Do not use extension cords or power strips to connect the unit.
33. Do not lead the power cable on top of the appliance or near the heat radiating surface.
34. Do not lead the power cable under carpets, door mats, etc.!
35. The appliance should be located so as to allow easy access and removal of the power plug!
36. Lead the power cable so as to prevent it from being pulled out accidentally or tripped over.
37. The unit is intended for household use. No industrial use is permitted!
38. Due to continuous improvements, the technical data and design may change without any prior notice.
39. The actual instruction manual can be downloaded from www.somogyi.hu website.
40. We don’t take the responsibility for printing errors which may occur, and apologize for them.
CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble or modify the unit or its accessories. In case any part is damaged, immediately
power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the manufacturer, its
service facility or similarly qualified personnel.
DO NOT COVER!
COVERING THE UNIT CAN CAUSE OVERHEATING, FIRE OR ELECTRIC SHOCK.
SETUP
1. Before switching on for the first time, carefully remove the packaging material taking care not to damage the
appliance and power cable. Do not use the product if it is damaged in any way!
2. The unit may only be used indoors in dry conditions.
3. The base has to be assembled to the appliance.
a.
Remove the two screws that fasten the feet from unit’s base.
b.
Unwind the power cable completely and lead it through the center of the base.
c.
Mount the base on the bottom of the appliance. The cable holder (11) should face the rear of the appliance.
d.
Fasten the base using the two screws.
e.
Fasten the power cable using the cable holder.
4. Set the appliance on a stable and horizontal surface. Do not place on flammable materials such as wood, carpet,
etc. The unit should only be placed on non-flammable materials such as stone, marble or floor tiles.
5. The free flow of warm air must be ensured for proper operation, therefore, please note the minimum installation
distances indicated in
Figure 2
. Do not locate the appliance directly below or next to a wall outlet.
6. Verify that the unit’s mains switch (3) is in the OFF “0” position.
7. Plug the unit’s standard grounded AC power cable into a grounded wall outlet. This completes the setup of the
appliance.
