Somnera 67890, Инструкция по эксплуатации

Страница: 16 / 24

14
6. Headgear Cleaning
6.1. Submerge the headgear straps in the soapy water and agitate for at least 5 seconds.
6.2. While submerged, use a finger or soft brush to gently rub both sides of each strap
6.3. Clean until you do not see any visible debris on the straps.
7. Remove all of the components from the basin or container.
8. Rinse each of the components under warm running water for at least 5 seconds. Continue
rinsing until no visible soap remains, then set aside each component on a towel to dry.
8.1. Make sure to rinse both the inside and outside of the mask and hose with warm
running water.
9. Hang the hose over a hook so that both ends are facing downwards to allow the hose to
drain and facilitate drying.
10. Allow all of the components to air dry out of direct sunlight before reassembling for the
next use.
Warning
Do not use aromatic-based solutions or scented oils, (e.g. eucalyptus or essential oils) bleach,
alcohol or products that smell strongly (e.g. citrus) to clean any of the mask components. Residual
vapors from these solutions can be inhaled if not rinsed thoroughly. They may also damage the
mask, causing cracks.
Caution
If any visible deterioration of a system component is apparent (cracking, crazing, tears or cushion
damage), the component should be discarded and replaced.
Caution
The frequency of cleaning, methods of cleaning, or the use of cleaning agents, other than those
specified in this document can have an adverse effect on the materials or performance.