Somnera 67890, Инструкция по эксплуатации

Страница: 15 / 24

13
CLEANING THE PATIENT INTERFACE
Note: Patient Interface Components should only be hand washed in warm water using mild,
unscented dishwashing soap. All components should be rinsed well with drinking quality water
and allowed to air dry out of direct sunlight.
Daily/After each use:
1. Disassemble into the 5 individual components before cleaning: Mask (nasal pillow or nasal
mask), valve, hose, and 2 headgear straps.
2. Fill a clean basin or container with warm water and add enough mild, unscented dishwashing
soap (e.g., Dawn) until soap bubbles form.
3. Mask Cleaning
3.1. Submerge the mask in the soapy water and agitate for at least 5 seconds.
3.2. While submerged, use a finger or soft brush to gently rub the inside and outside
of the mask.
3.3. Clean until you do not see any visible debris on the mask.
4. Valve Cleaning
4.1. Submerge the valve in the soapy water and agitate for at least 5 seconds.
4.2. While submerged, use a finger or soft brush to gently rub both sides of the valve.
4.3. Clean until you do not see any visible debris on the valve.
5. Hose Cleaning
5.1. Submerge the hose in the soapy water and agitate for at least 5 seconds.
5.2. Then use your thumbs to plug both ends of the hose, remove from the sink or basin,
and move the hose ends up and down to help clean the inside of the hose.
5.3. Return the hose to the sink or basin and clean until you do not see any visible debris
on the hose.