Sommer GmbH
15
o
Click on
one of the listed sensors
.
By clicking one of the sensors it will be
connected. The first time a sensor is
connected the dialog shown right will pop up.
o
The input of a description is only
necessary, if more than one conductivity
sensor is used for the TQ-Amp.
o
As ID the use of a capital letter is
recommended. An assortment of letter
stickers is included and can be placed
on the TQ-Amp.
o
Repeat this process for all sensors, then ...
After establishing the connection and setting
up the sensor they are listed as green
entries.
To check the connection status on the TQ-
Amp please consult
the “Connect”-LED,
which will now be switched on (green).
o
As soon as all sensors necessary for the measurement are connected, proceed by clicking
Ok
(F2)
.
o
The sensor setup is now complete and a measurement can be started by clicking
Next (F2)
.
6.4. Removing a sensor
If a sensor is not needed any more, it can be disconnected by deactivating
“Autoconnect” (see above
screenshot). To remove a sensor, please proceed as described below:
Menu
Data (F10)
Sensor
