OPERATION
Page 17
8.3.2
Adjusting the crushing gap
Adjust the gap to match the desired results and the size of the material to be crushed.
NOTE
Damage caused by tools!
Only adjust the crushing gap manually. The use of tools can cause damage to the
adjustment gear.
Requirements:
The machine is switched off
The feed gate is closed.
There is no milling material on the pinch rollers.
Steps:
1.
Adjust the crushing gap; to do so:
1.1. Loosen the clamping lever on the back of the machine and turn the adjusting lever
8.3.3
Reduce the crushing gap
NOTE
Damage caused by accumulations of milling material!
Clogging of the outlet (e.g., due to backlogs) can result in damage to the machine.
Replace catchment sacks or catchment containers regularly with empty ones.
Verify that
The rolled material can drop freely downwards out of the machine.
The rolled material does not accumulate up to the bottom edge of the machine outlet.
8.3.4
Ejecting foreign bodies
Remove foreign bodies (e.g., small stones) from the pinch rollers.
Requirements:
The machine is running.
Steps:
1.
Pull the handle on the foreign body ejector while the machine is running.
