EN
Sunea 40 RTS DC
12
Copyright
©
2020 SOMFY ACTIVITES SA. All rights reserved.
1]
Position the motorised product at the mid-height position.
2]
To activate the “Closing force” function, make two successive presses:
• Firstly, press the my and Up buttons briefly and simultaneously, with no
moving of the motorised product.
• Secondly, press and hold the my and Up buttons simultaneously, until the
motorised product moves up and down.
ð
The drive is now in programming mode
for only 10 seconds
. By default,
the drive is factory set at the medium level.
3]
To increase the closing force, press the
Up
button until the motorised
product makes a slow movement:
ð
The cassette’s closing force has moved up a level.
4]
To decrease the closing force, press the
Down
button until the motorised
product makes a slow movement:
ð
The cassette’s closing force has moved down a level.
5]
To confirm the new setting, press the
my
button until the motorised product
moves up and down.
g
The “Closing force” function is reset.
0.5 s
1]
2]
3]
5]
4]
2.3.8.Adding/Deleting RTS sensors
1]
To add or delete an RTS sensor, press and hold the
PROG
button on the
programmed control point until the motorised product briefly moves up and
down.
2]
Briefly press the
PROG
button on the RTS sensor to be added/deleted: the
motorised product briefly moves up and down.
g
The sensor is added/deleted.
1]
2]
2 s
PROG.
0.5 s
PROG.
NOTICE
If the RTS sensor on an installation is changed or deleted, it is important to delete it from the memory of all the drives
in which it was programmed: perform step 1 with a programmed control point, then perform step 2 with the sensor to
be deleted.
5113030C_Sunea 40 RTS DC.pdf 12
10/19/2020 5:49:32 PM
