SOMFY Sonesse 40 RS485, Инструкция по эксплуатации

Страница: 7 / 112

Sonesse 40 RS485 EN
Copyright © 2021 SOMFY ACTIVITES SA. All rights reserved. 7
3.USE AND MAINTENANCE
NOTICE
This drive does not require any maintenance operations.
CAUTION
• For the safety of goods and people, Somfy drives are equipped with thermal protection that will trigger the drive
stops in the event of overheating.
• Repeated activation of this protection can degrade drive performance.
• If the drive goes to thermal protection, please check your installation and check that the drive is rated for the
intended use.
• A normal installation is not expected to trigger this protection.
NOTICE
When some functions require a power cut, the power cut is only taken into account if it lasts more than 10 seconds.
3.1.Operation
To control the drive, please refer to the installation instructions of the used control point.
3.2.PROG button
In user mode, control drive UP / Stop / Down / Stop Short press (< 1,5 s)
Post node ID on the network Press until first feedback (about 2 s)
Reset drive to factory Press until third feedback (about 12 s)
3.3.LED feedback
LED colors Feedbacks Possible causes
Green lights fixed ON for 2 seconds at Power ON. Power is ON.
blinks 5 times. Validation setting is done.
lights ON then lights OFF shortly. Bus communication. (It could be disable by SDN
order).
Orange lights fixed ON Drive not set.
blinks 2 times. Push node ID to the SDN network.
Red lights fixed ON The drive has detected an obstacle.
lights ON then lights OFF. The crown does not turn.
Wait for the drive to cool down to restart the
drive.
Do not touch the drive: risk of burns.
blinks 2 times. Drive position is out of limits.
flashes in 3 sets of 3 blinks. Setting is impossible.