SOMFY Sonesse 40 RS485, Инструкция по эксплуатации

Страница: 6 / 112

EN Sonesse 40 RS485
6 Copyright © 2021 SOMFY ACTIVITES SA. All rights reserved.
2.3.Commissioning
The drive has 2 blinds profile inside:
▪
Roller mode (to control all blinds except Venetians).
▪
Venetian mode.
Two tools are available to set the drive.
▪
RS485 SETTING TOOL: Connect the RS485 SETTING TOOL to the drive
switch on and follow the instruction on the RS485 SETTING TOOL.
NOTICE
• Venetian mode allows to manage the tilt and the lift position. It is not
possible to set the drive-in venetian mode through the RS485 SETTING
TOOL.
• When setting end limits, take care that the load bar remains free at upper end
Limit.
▪
SDN Config Tool: Somfy Digital Network Configuration Tool.
NOTICE
The SDN Config Tool is available for download at https://www.somfy.com/projects/downloads
NOTICE
The different versions of which are available in the current Somfy catalogue.
2.4.Tips and advice on installation
2.4.1.Questions about the drive?
Observations Possible causes Solutions
The motorised
product does not
work. "Power" or "datas" wiring are incorrect. Check the wiring and modify it if necessary.
The drive is in thermal protection mode. LED
Red = ON then lights OFF. Wait for the drive to cool down to restart the
drive.
Do not touch the drive: risk of burns.
An incorrect Data cable has been used Check the Data cable.
End-limits are not properly adjusted. Adjust the end-limits.
The motorised
product is noisy. The wheel and the crown are not adapted to the
used tube. Change the wheel and the crown.
The mechanical plays between drive, accessories,
tube and end of tube are too high. The mechanical plays between drive, accessories,
tube and end of tube must be decreased to the
minimum.
The wheel is not properly fixed to the tube. Fix the wheel properly to the tube.
The equipment is constrained between the
brackets. Decrease the constraint between the brackets.
The length of the notch is not adapted to the drive
hook or to the used crown. Adapt the length of the notch to the drive hook or
to the used crown.
Debris, screws or other are in the tube. Empty the tube.
The temperature of the environment is not in
conformity with the operating temperature. Change the environment temperature.
The motorised
product stops too
soon or too late. The end limits of the motorised product slip. Re-set the end limits.
The motorised product does not fall within the
recommended weight limits. Check the compatibility of the motorised product.
Consult a Somfy contact or visit www.somfy.com.