Pergola io
44
EN
Copyright © 2010-2017 Somfy Activités SA, Société Anonyme. All rights reserved.
3.3. Motor/tube assembly
1) Slide the motor into the roller tube.
For smooth roller tubes, position the notch previously cut
on the crown.
2)
For safety reasons, fix the roller tube to the drive wheel
with 4 x Ø 5 mm self-tapping screws or 4 x Ø 4.8 mm
steel pop rivets located:
- at least 5 mm from the outer rim of the drive wheel:
L1 - 5, and
- no more than 15 mm from the outer rim of the drive
wheel: L1 - 15.
The screws or pop rivets must only be attached to the
drive wheel and not to the motor.
3.4. Installing the tube/motor assembly
1) Fit the tube/motor assembly to the end bracket (C).
2) Fit the tube/motor assembly to the motor bracket (D).
3) Depending on the type of bracket, position the retaining ring
(E) (for motors ≥ 85 Nm with a retaining ring, it is essential
to use the locking retaining ring (F)).
15 mm
5 mm
20 mm
L1
1
2
C
D
E
F
1
2
3
- Cut off the mains power supply.
- Connect the motor according to the information in the
table below:
230 V ~ 50 Hz
Motor cable
1 Brown
Live (P)
2 Blue
Neutral (N)
3 Yellow/Green
Earth ( )
1
2
3
1
2
3
OFF
230 V
~
50 Hz
3 x 1.5 mm
2
3 x 0.75 mm
2
4. WIRING
