SOMFY ilmo2 50 WT, Инструкция по эксплуатации

Страница: 14 / 36

12
EN
ILMO2 50 CSI WT
Copyright
©
2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
2.1.5. Mounting the tube-drive assembly
Fit and attach the tube-drive assembly to the end bracket
f
and the
drive bracket
g
.
Attention
Ensure that the drive-tube assembly is secured onto the end
bracket. This operation prevents the drive-tube assembly from
coming out of the end bracket mounting.
2.2. WIRING
Attention
• Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
• Attach cables to prevent any contact with moving parts.
• If the drive is used outdoors, and if the power supply cable is a type H05-VVF cable, the cable should be
installed in a UV-resistant duct, e.g. under a gland.
• The ILMO2 50 VSI WT cable can be removed. If it becomes damaged, replace it with an identical cable.
• Leave the drive power supply cable accessible: it must be easy to replace.
• Always make a loop in the power supply cable to prevent water entering the drive!
- Switch off the power supply.
- Connect the drive and the control point according to the in-
formation provided in the table below.
230 V 50 Hz
1 Neutral (N) Blue
2 Live (up or down) (L) Brown
3 Live (up or down) (L) Black
4 Earth Green/Yellow
͉
͉
Depending on the maximum load current of the control point and depending on the types of motors, several motors
can be connected in parallel to a single control point.
͉
͉
To integrate a motor into a Somfy system, using a Somfy motor controller, the connection requirements in the
controller manual must be followed carefully.
͉
͉
Control points with a “semi-conductor” relay must not be used.
f
g
L ≤ 50 m
4
230 V 50 Hz
1 2 3
OFF