SOMFY Home Motion LEVIXO 30 RTS, Руководство по установке

Страница: 25 / 76

Copyright © 2011 Somfy SAS. All rights reserved.
5
EN
Levixo 30-50 RTS
4. iNstallatioN
4.1. mounting the housing with a base plate (optional) and concrete base
If the housing is mounted without a base plate, go straight to
section 4.2.
Before opening the door of the housing, it is
essential to ensure that the spring is released by
moving the boom to the vertical position.
The door of the housing must be facing inside the
property.
- Make a hole in the base suitable for the type of terrain.
- Use several ducts to route the electrical cables.
- Place 4 bolts supplied with the base plate in the final
position with the thread of the bolt facing upwards and
weld the heads of the 4 bolts to the base ( 1 ). Protect the
welds with an anti-rust product. Position the base so that it
protrudes the ground by approximately 20 mm ( 2 ).
- Fill the base with concrete, using a spirit level to check the
position of the base in both directions ( 3 ) and leave the
cement to harden.
V
V
12
35
1
2
3 3
1
2
3
5
4
4.2. mounting the housing without a
base plate
Before opening the door of the housing, it is
essential to ensure that the spring is released by
moving the boom to the vertical position.
The door of the housing must be facing inside the
property.
Follow the instructions in the figure opposite.
Note: The plugs are not supplied.
Secure the housing by tightening the M12 nuts.
The top surface of the actuator is angled slightly to prevent
rain water from collecting. Use a side surface instead to check
that the housing is correctly level.