EN
Copyright © 2016 Somfy SAS. All rights reserved.
8
[6].
Briefly press the PROG button at the back of the monitor (above the battery housing).
-
The indicator light on the receiver flashes for 5 seconds.
[4]
[5]
[3]
2s
1..2..3..4..5
2 mn
2 s
5 s
5 s
[7].
Return the monitor to its rear section (see 3.1 General information, page 5).
Note: To clear the video entry phone programming on a Somfy light receiver, repeat all the steps detailed above.
3.5 Programming a Somfy RTS gate motorisation
[1].
Remove the monitor from its rear section (see 3.1 General information, page 5).
[2].
Open the cover on the control cabinet or the motor containing the electronics.
[3].
Check that the motor is powered on.
[4].
Select the desired channel by pressing the channel selection button on the monitor.
[5].
Place the monitor on the target on the motor electronic unit.
Important: The le-hand section of the monitor must be placed on the electronic unit target so that the monitor can be
correctly detected by the motor electronics.
[6].
Briefly press the monitor opening button.
-
The RADIO indicator lights on the motor electronic unit lights up then goes out.
[4]
[5]
1..2..3..4..5
< 0,5s
[7].
Close the cover on the control cabinet or the motor.
[8].
Return the monitor to its rear section (see 3.1 General information, page 5).
Note: To clear the video entry phone programming on a Somfy gate motorisation, see the motorisation guide.
4 USING THE RTS MONITOR CONTROL
[1].
Select the desired channel.
[2].
Press
to open the relative product (roller shutter, awning, garage door, etc.) or to switch the light on.
[3].
Press
to close the relative product or to switch the light off.
[4].
Press
to:
-
stop the relative product currently being moved.
-
reach the favourite position if programmed.
4.1 Saving or modifying the favourite position
When the relative product is moving:
[1].
Stop the product in the desired position
[2].
Press
for 5 seconds.