SOMFY 1115202, Руководство по установке

Страница: 20 / 80

Copyright © 2009 Somfy SAS. All rights reserved.
Sunea CSI RTS
18
EN
7.5 Advanced functions
Contact the awning’s manufacturer before using these functions to check the compatibility of your
systems.
7.5.1 « Back impulse » function
This function allows to tighten the fabric each time the
awning is powered. It is possible to adjust it until
turn of
roller tube.
To activate this function :
Set the awning to the lower end limit.. 1)
Press the “my” and Up buttons simultaneously until 2)
the awning makes a movement : the motor is in
programming mode.
Adjust the fabric’s tension using the Up and Down
3)
buttons (1/2 turn of tube max.).
Press the “my” button until the awning makes a
4)
movement : the fabric’s tension has been programmed.
7.5.2 « Back release » function on cassette awnings only
This function allows the fabric tension to be released after the cassette awning is closed.
The procedure for activating and deactivating the “Back release” function is the same.
For safety reasons, this function can only be activated or deactivated by the RTS control point in 3
situations :
After the 2 seconds stop to confirm settings and before programming the first RTS control point. •
After programming the first RTS control point and during the next 4 cycles. •
After a single power outage and during the next 4 cycles. •
To activate this function :
Set the awning to the upper end limit position. 1)
Press the “my” and Down buttons simultaneous until the 2)
awning makes a movement.
If the Back release function was inactive, it is activated.
If the Back release function was active, it is deactivated.
7.5.3 « Closing force » function on cassette awnings only
This function enables the closing force of the awning cassette to be increased or decreased to 3 levels
(high/medium/low).
The motor is factory set at the medium level.
For safety reasons, this function can only be accessed via the RTS control point in 3 situations:
After the 2 seconds stop to confirm settings and before programming the first RTS control point. •
After programming the first RTS control point and during the next 4 cycles. •
After a single power outage and during the next 4 cycles. •
To activate this function :
Set the awning to the halfway position. 1)
Press briefly the “my” and Up buttons simultaneously, 2)
then immediately press and hold the “my” and Up
buttons simultaneously until the awning makes a
movement.
The motor is in programming mode for only
approximately 10 seconds.
Adjust the closing force using the Up or Down buttons. 3)
To increase the closing force, press the Up button -
until the motor makes a slow movement : the cassette
awning’s closing force has moved up a level.
To decrease the closing force, press the Down button until the motor makes a slow movement :
-
the cassette awning’s closing force has moved down a level.
Press the “my” button until the awning makes a movement: The new closing force has been 4)
programmed.
1 2
4 3
or
1 2
or
or
0.5 secs 5 secs
1 2
3 4